The schematic in the Starter Kit Manual seems to be the generic one for BT+GPS+FM. Can you please provide a recommended schematic for BT and GPS only and, if available, a recommended PCB layout?

Administrator

Monday, December 13th 2010, 5:29pm

The schematic in the Starter Kit Manual seems to be the generic one for BT+GPS+FM. Can you please provide a recommended schematic for BT and GPS only and, if available, a recommended PCB layout?

You can use the generic schematic only removing the FM RX + TX RF section and choose your preferred UART mode. Please avoid using ferrite beads for power supply decoupling. The Starter Kit layout shows no significant influences about EMC

Go to the top of the page

Similar threads

- TC6000 GB »
- Does the TC6000GB (GPS & BT) have different layout footprint than the one with FM function? If the TC6000GB has the generic footprint as other modules, how should the unused FM related pins be terminated? (Dec 13th 2010, 5:24pm)
- TC6000 G »
- lots of customers would like to use small uC like 8-Bit µC from Infineon, ATMEL, Cypres for using with TC6000 is that possible ? (Dec 13th 2010, 5:23pm)
- TC6000 GB »
- Will you also provide in the future a bluetooth stack which can be ported to a small embedded processor? Or what do you recommend in such case? (Dec 13th 2010, 5:04pm)
- TC6000 GB »
- GNS will most likely be able to provide a bluetooth stack from TI+Samsung ? (Dec 13th 2010, 5:01pm)

GNS Support Forum

The schematic in the Starter Kit Manual seems to be the generic one for BT+GPS+FM. Can you please provide a recommended schematic for BT and GPS only and, if available, a recommended PCB layout?

The schematic in the Starter Kit Manual seems to be the generic one for BT+GPS+FM. Can you please provide a recommended schematic for BT and GPS only and, if available, a recommended PCB layout?

Similar threads